LDG AT100PRO

$124.95

VERY NICE AND CLEAN 
Optional AL-PAC (for Alinco), Y-ACC (for FT-897/857), or 6 foot IC-PAC-6 (for Icom) 

The LDG AT-100Pro is the next step in the evolution of the automatic tuner. This desktop tuner covers all frequencies from 1.8 – 54 MHz, and will automatically match your antenna in no time.

It features a two-position antenna switch, allowing you to switch instantly between two antennas. The AT-100Pro requires just 1 watt for operation, but will handle up to 125 watts, making it suitable for everything from QRP to a typical 100 watt transceiver.

The AT-100Pro includes over 2,000 memories for each antenna, automatically storing tuning configurations for each frequency and band as you use them. Frequency sensing circuitry lets the AT-100Pro “know” your operating band and frequency. Whenever you transmit on or near a frequency you’ve used before, the AT-100Pro can retune from memory almost instantly.

Rugged and easy-to-read LED bargraphs show power and SWR, and a Function key on the front panel allows you to access data like mode and status. The AT-100Pro uses latching relays which retain the tuned configuration indefinitely even when powered down; current draw when not tuning is effectively zero.

The AT-100Pro uses LDG’s state-of-the-art processor-controlled Switched-L tuning network. It will match dipoles, verticals, inverted-Vees or virtually any coax-fed antenna. With an optional LDG balun, you can also use longwires or antennas fed with ladder-line.

Control from the front panel is simple and straightforward; just press Tune while transmitting a carrier, and the AT-100Pro will begin an automatic tuning cycle.


Add to Cart:


Your IP Address is: 54.80.8.44
Copyright © 2013 - 2018 The Hamstation. Powered by Zen Cart Website Hosted by QTH.com